Chain Plates

The forward chain plates were generally in good condition although coated in rust. Chain Plates00009

The rear chain plates were also extremely rusty but were attached to the topside through rotten timbers. Structurally all six rear chain plates were unsound and had to be removed and the supporting timbers replaced.

The forward chain plates were all sand blasted back to bear metal and then 2 coats of Jotamastic 90 epoxy undercoat applied. They were then painted with a two pack epoxy black enamel. All the rear chain plates were completely removed from the vessel.

Original chain plate set-up Feb 2016
Original chain plate set-up Feb 201

The woodwork under the rear chain plates was replaced with hardwood bearers tied to the deck supports. This meant that both the port and starboard side rear top deck walls had to be removed and rebuilt. New 150mm X 150mm hardwood  bearers were inserted as primary support for  the chain plates. The exterior was then covered with 2 layers of epoxy treated 19 mm marine ply. Continue reading “Chain Plates”